| Preparation of Culture Media
 Culture  media are essential for isolation of mushroom fungi and maintaining them in a  pure culture either in test tubes or in Petri plates. The fungal cultures may  be grown in liquid media (broths) or on solid agar media. ( Agar agar is a  solidifying material obtained from sea seed weed like Geladium sp., which melts on boiling and solidifies upon cooling). Some  of the commonly used media are listed below:i) Potato dextrose agar (PDA):   
                
                  
                    | Potato | 250 g |  
                    | Dextrose | 20 g |  
                    | Agar agar | 20 g |  
                    | Distilled water | 1000 ml. (pH : 7) |                 ii) Oatmeal  agar (OA)
 
                
                  
                    | Oatmeal | 30 g |  
                    | Agar agar | 20 g |  
                    | Distilled water | 1000 ml. (pH : 7) |                                   iii) Wheat  meal agar (WMA) 
                
                  
                    | Wheat grain | 30 g |  
                    | Agar agar | 30 g |  
                    | Distilled water | 1000 ml. (pH : 7) |  iv) Malt  extract agar (MEA)
 
                
                  
                    | Malt extract | 25 g |  
                    | Agar agar | 20 g |  
                    | Distilled water | 1000 ml.  (pH : 7) |   v) Yeast  potato dextrose agar (YPDA) 
                
                  
                    | Yeast granules | 1 g |  
                    | Potato | 200 g |  
                    | Dextrose | 20 g |  
                    | Agar agar | 20 g |  
                    | Distilled water | 1000ml (pH: 7) |                          Potato dextrose agar  (PDA):
 Potato dextrose agar medium is very commonly used for  isolation of fungus as well as for its maintenance.  Procedure:  
                
                  Wash  250 g potato, peel off the skin, and slice them into small pieces.Cook  the sliced potato in 500 ml. water for 30 minutes in an open vessel or pressure  cooker for 20 minutes.Simultaneously  mix 20 g agar with 500 ml. of water and boil in a cooker for 30  minutes.Collect  the potato extract by filter through muslin cloth or net filter.Add 20  g dextrose to the potato extractMix  thoroughly the molten agar with the potato- agar mixture and make the volume 
                    to 1  litre with distilled water.  
Check  the pH of the medium using pH papers. Pour the medium in to cleaned  boiling tubes @ 15 ml / tube and plug with non-
                    absorbent cotton wool.Arrange the tubes in a wire basket,  cover it with a waste paper sheet and tie tightly 
                    with a cotton thread.Sterilize them in an autoclave or  a pressure cooker at 15 lbs pressure for 20 
                    minutes.Take out the sterilized tubes  after releasing the steam and keep them in a slanting 
                    position to get agar slants.
                               After solidifying, the tubes are  arranged in a wire basket and stored in a clean 
                    room for further use.
 
 Procedure for checking pH:  Stir the medium with a glass rod and take a small bit of  pH indicator paper and dip it in the medium.  Take it out and compare the colour development with the colour chart given on  the cover sheet of the filter paper book. If pH is above 7, add a few drops of  0.1N Hydrochloric acid (HCl), stir well and again check the pH for neutral.  Contrastingly, if the pH of the medium is below 7, add a few drops of 0.1 N  Sodium hydroxide (NaOH) to increase the pH to 7.
 
                
                  |  |  
                  | Boiling potatoes | Boiling agar | Potato extract + agar+ sugar |  
 
                
                  |  |  
                  | Sterilization | PDA media | Pouring in Petri plates |  |